Lowrance Electronics Sonar, StructureScan, DownScan, 3D, CHIRP explained by a Lowrance Expert Ken Sauret

Mysteries Solved for Lowrance Electronics

3

When you connect to an

existing hot and ground source,

you don’t really know how many

devices are already using that

wire and if you overload the

carrying capacity of that wire

many kinds of failure can result.

I like to recommend leaving

the existing wiring alone relying

on the engineers at the boat

manufacturer to have designed

the wiring harness to do its job

without any problems. I feel

they size the wire to the load

intended and connected to

those wires. I don’t want to add

more load to that wire. I feel it is

prudent to run dedicated wire

to run your new electronics

to avoid any unnecessary

problems later.

Dual Bow Mount Dual Dash Mount

QUESTION #3

I just bought a new Ranger Z series boat. What is the best method to mount my Lowrance HDS units on my boat? I have seen them flush mounted; but at the console, the steering wheel blocks some of the lower part of the screen and I don’t like that. Solutions?”

ANSWER #3

The historical method was to get a RAM mount and place the units off to the side of the windshield. I recently purchased a new Ranger Z521C with flush mounted Lowrance HDS-12 Gen3’s at the console and at the bow. I had the same issue with the steering wheel blocking the lower 1/3 of the screen. I didn’t like that either.

The solution I found to be the best is getting a Bass Boat Technologies dash mount. There are lots of choices on the bassboattech.com website; but the one for the Ranger boat I purchased was perfect.

FALL 2017

When I removed the flush mounted Gen3 there was a hole in the dash cover. The Bass Boat Technologies dash mount that comes for the Z521C fits the same screw hole pattern as the stock cover. All you do is remove the star head screws in the Ranger dash cover, remove the cover and the new Bass Boat Technologies mount fits the same hole pattern and covers up the hole perfectly. The new mount was very easy to install and lifts the Lowrance unit just above the steering wheel, but does not block my view.

I would like to elaborate a little on my decision to install the Bass Boat Technologies mount. I’m sure all of you have watched the Bassmaster and FLW Tour events on television. We have all seen the two

71