Pairing is only necessary the first time you use your MOB+™. Press and hold the button on your xHUB™.
Release the button when the xHUB starts flashing blue and gives a sound signal indicating Pairing Mode.
Immediately after releasing the button on the xHUB, press and hold the button on your xFOB™.
The xHUB will give a sound signal and a green light to indicate a successfull pairing.
Click the button on your xFOB to connect.
The xHUB will give a sound signal and a green light to indicate a successful connection.
Click the button on your xFOB to disconnect.
The xHUB will give a sound signal and a red light to indicate Disconnect.
In the event that you forget your xFOB™ or if it´s out of battery - don´t worry. You can easily override MOB+™ by holding the button on the xHUB™ for 13 seconds. The xHUB will give a sound and light signal to indicate Override Mode is activated so you can start boating.
• I already have an existing cut-off switch. Can I install MOB+™?
-Yes. MOB+ is installed using wires from your existing cut-off
switch. Please see installation guide for instructions • I have a boat made from metal. Can I install MOB+?
-Actual signal reduction, if any, will vary from boat to boat.
Should the signal be noticeably worse, we recommend using
an external antenna to put on the top side of the helm,
supplied from FELL Marine. • Can passengers start the boat if I were to fall over board?
-Yes, this is one of the main features of MOB+. 6 seconds
after a MOB Event the system lets passenger restart the
engine to pick up the missing person in the water.
w Fo w l w lo .f w ace u bo s o o k. n co f m a / c fe e ll b m o a o rin k e !
See our online user manual at www.fellmarine.com
We have made it super easy for you to find what you are looking for by creating an online interactive user manual. Just tune in on www.fellmarine.com for the latest news and information available about our products.http://www.fellmarine.com http://www.facebook.com/fellmarine