BassCat2017 Catalog, Page 3

BassCat2017 Catalog, Page 3

CONSTRUCTION AND COMPONENTS

1. Quality Gel Coat Application

Strategic steps, high atomization, and a wet flake application gives a BCB gel coat the look, feel, and consistency that is unmatched in our industry.

2. Finishing Department

The important key in our finishing department is the fact that all electrical, plumbing, and fuel rigging is done after the boat is assembled. This equates to easier access to batteries and pumps making maintenance procedures easier, which ultimately decreases your cost of ownership.

3. Full Width Transom Strength

Everyone talks about how strong their transoms are. None compare to the BCB all fiberglass, vacuum molded units that extends the entire width of the hull. No fillers are used as we set into wet fiberglass to secure them to the hull boat.

4. Vacuum Process Hull Assembly

One-piece stringers, floors, and transoms are pulled together using massive vacuum pumps. This creates our famous one piece hull design that you can truly feel as you pass the competition on the water.

5. 6-Bolt Custom Jack Plates

The custom plates made for Bass Cat are a big deal. Added rail length, full transom support, and an extra tie bar gives you the advantage on big water.

6. 24 Ounce Marine Grade Carpet

Not all marine carpet is equal. We use the heaviest grade available; 24 ounce per square foot. This carpet goes in every Bass Cat model for better wear, less fatigue, and longer life.

7. No-Plastic Dash Assembly

Elegant, drilled-to-fit dashes will stand up to the test of time...and any rough water you may encounter. All fiberglass construction with color coordinated gauge bezels for a nice touch.

8. BCB Trailers

Our trailers are built in-house, with the same intensity and passion that goes into our boats. All are custom fit to each model and made with U.S. steel.

1 5

As you do your homework on our boats, we encourage you to look below the clean lines, deep gel coat, and high quality components.

The pure vinyl ester resin that binds our vacuum molded assemblies creates a true one-piece hull and structural integrity that is unmatched.

Every aspect of a Bass Cat is built to outlast your years of use, decrease your overall cost

of ownership, and retain the value of your Cat that others can’t touch.

Our transparent factory tours are available to everyone. Stop in and see for yourself!

-Online Factory Tour- Available on YouTube

and BassCat.com

CONSTRUCTION

23

4

COMPONENTS

6 7 8 3